Beko DIS15011 User Manual page 15

Preparation
a b
Remove the test Turn on the tap and
strip from the let the water run for
packet. about a minute.
After determining hardness level of the supply water:
1. Switch on the machine and press the Time Delay and P keys simultaneously. Hold
the keys pressed until entering the Settings menu. Rinse Aid and Salt indicators (model
dependant) will flash on the display.
2. Select the salt indicator with the program key. Current regeneration level is displayed on
the display.
3. Using Time Delay key, adjust water hardness level according to the hardness of the
supply water. For correct setting please see "Water hardness level adjustment table".
4. Press On / Off key to save the setting.
Water hardness level adjustment table
Hardness English Water
Level Hardness °dE
0th Level
0-5
1st Level
6-9
2nd Level
10-15
3rd Level
16-19
4th Level
20-24
5th Level
25-62
If the hardness level of the supply water is above 90 °dF or if you are using well water,
then it is recommended to use water purification devices and special filters.
If the hardness level of the supply water is below 13°dF, there is no need to use salt in your
dishwasher. If this is the case, "No Salt Warning Indicator" (if any) illuminates continuously
on the panel of your machine.
If the water hardness level adjustment is set to level 1, the "No salt warning indicator" will
illuminate continuously although it is not necessary to use salt. If you use salt under this
condition, salt will not be consumed and the Salt indicator will not illuminate.
Dishwasher / User's Manual
c
1 min.
1 Second
Hold the test strip in
the water for about
a second.
German Water French Water
Hardness °dH Hardness °dF
0-4 0-8
5-7 9-13
8-12 14-22
13-15 23-27
16-19 28-34
20-50 35-90
d e
Remove the test Wait for 1 minute.
strip from the water
and shake it.
Water Hardness Level Indicator
Press the Time Delay key to switch the water hardness
level to position P1.
Press the Time Delay key to switch the water hardness
level to position P2.
Press the Time Delay key to switch the water hardness
level to position P3.
Press the Time Delay key to switch the water hardness
level to position P4.
Press the Time Delay key to switch the water hardness
level to position P5.
f
1 Minute
The test strip shows
you the hardness
level.
13 / 41 EN