Table of Contents
Advertisement
Requirement
• The device is in operation.
• The function "Reset to Factory Defaults" is enabled for the "SELECT / SET" button.
Note
Reset despite disabled "SELECT/SET" button
If you have disabled the "Restore Factory Defaults" function for the "SELECT/SET"
button in the configuration, this does not apply during the startup phase, see section
"Restoring the factory settings (Page 66)".
If the function has been disabled in the configuration, it is only disabled on
completion of the startup phase.
Procedure
To reset the device to the factory defaults during operation, follow the steps below:
1. Switch to display mode A.
Display mode A is active if the LEDS "DM1" and "DM2" are unlit.
If the "DM1" and "DM2" LEDs are lit or flashing, you will need to press the
"SET/SELECT" repeatedly until the "DM1" and "DM2" LEDs go off.
If you do not press the "SELECT/SET" button for longer than 1 minute, the device
automatically changes to display mode A.
2. Hold down the "SELECT/SET" button for 12 seconds.
After 9 seconds, the "DM1" and "DM2" LEDs start to flash for 3 seconds. At the same
time, the port LEDs go on one after the other.
After you have held down the button for 12 seconds, the device restarts and the
factory defaults are restored.
If you release the button before the 12 seconds have elapsed, the reset is canceled.
Enabling and disabling the button
In the configuration, you can enable or disable the button function.
Defining the fault mask
Using the fault mask, you specify an individual "good status" for the connected ports and
the power supply. Deviations from this status are displayed as errors/faults.
You configure newly plugged-in connections in the configuration.
SCALANCE SC-600
Operating Instructions, 10/2021, C79000-G8976-C453-04
Description of the device
4.6 SELECT/SET button
35
Advertisement
Table of Contents
