Advertisement
STEP 3 FRAME INSTALLATION
3. DISASSEMBLY: The FRONT FRAME and BACK FRAME
come pre-assembled with ball studs engaged in the
receivers. Separate the FRONT FRAME from the BACK
FRAME. Place the assembly face down on a protected
surface. At the location of the ball stud, insert a flat head
screwdriver between the FRONT FRAME and the BACK
FRAME and gently pry up to disengage the ball stud from
the receiver. Repeat for each corner. See Sketch 6.
SKETCH 6
4. BACK FRAME INSTALLATION: Position back frame equal
space top to bottom, side to side. Mark for 4 holes, center
punch and pre-drill with 1/16" drill bit. Secure frame with
4 SCREWS (E). See Sketch 7.
Mounting holes
Screw E
Equal gap
side to side
Equal gap top, bottom
Screw E
Mounting holes
SKETCH 7
SHARP ELECTRONICS CORPORATION
100 Paragon Drive, Montvale, New Jersey 07645
5. FRONT FRAME INSTALLATION: Place the FRONT
Mounting holes
Screw E
Screw E
Mounting holes
4
FRAME onto the BACK FRAME and align ball studs
and receivers. Secure the FRONT FRAME to the BACK
FRAME by firmly pushing the front frame onto the back
frame engaging the four (4) snap attachments. See
Sketch 8.
Attachment
SKETCH 8
For any other assistance or information about this kit,
please call Sharp's Customer Assistance Center at
1-800-BE-SHARP (1-800-237-4277)
Snap
TINSEB567MRR0
Advertisement
