Door Assembly - Panasonic NN-C784MF Service Manual

NOTE:
Do not pull by lead wires but make sure to pull
housing unless PCB or lead wire may break.
4.4.

Door assembly

1. Remove left and right door key spring from door arm with
plier.
NOTE:
Support door before removing door springs.
2. Remove door arm lever by pushing tab and turn clockwise.
3. Insert flat blade screwdriver to release hinge pin from left
hinge.
4. Slide out left hinge pin to release the door.
5. Slide out door arms from the oven to disconnect door
assembly.
6. Remove door arms from the door assembly.
To remove door C
7. Release catch hooks between door C and door A from
hinge pin side.
To remove door E
8. Remove screws holding door E to door A assembly.
NOTE:
After replacement of the defective component parts
of the door, reassemble it properly and adjustment
so as to prevent an excessive microwave leakage.
Adjustment of the door assembly.
9. When mounting the door to the oven, be sure to adjust the
door parallel to the cavity front plate by moving hinges back
or forward.
10. Adjust so that the upper portion of the door will touch firmly
to the oven cavity front plate, without pushing the door.
If the door assembly is not mounted properly, microwave
power may leak from the clearance between the door and
oven.
13
NN-C784MF