Table of Contents
Advertisement
HBD-DZ330/DZ710/DZ730
2-7.
MAIN BOARD
6 wire (flat type) (11 core) (CN471)
(DZ330/DZ730)
wire (flat type) (9 core) (CN472)
(DZ710)
5 wire (flat type) (24 core) (CN1101)
7 wire (flat type) (19 core) (CN504)
(DZ330/DZ730)
wire (flat type) (21 core) (CN505)
(DZ710)
9 wire (flat type) (5 core)
(CN1502)
qh two screws
(+BV3 (3-CR))
1 wire (flat type) (13 core) (CN507)
(DZ330/DZ730)
wire (flat type) (15 core) (CN506)
(DZ710)
Arranging the USB wire
Tie up with LP501.
14
8 CN1501 (6P)
USB wire
qd four screws
(+BV3 (3-CR))
qf heat sink
4 CN2101 (5P)
qg five screws
qj MAIN board
3 CN904 (5P)
2 CN906 (11P)
The USB wire should be located on the front side
from these capacitors.
Thread the USB wire through
the capacitors.
Dress the USB wire in this area
properly along the board.
MAIN board
(+BV3 (3-CR))
When the heat sink
has been removed,
apply oil compound
(G-747) to it.
0 two screws
(+BV3 (3-CR))
qa insulated plate
(PC-DSZ)
qs shield plate (PC-DSZ)
USB wire
Advertisement
Table of Contents
