Baby Monitor - Panasonic KX-TGJ420E Operating Instructions Manual

Programming
Setting the ring delay
This setting allows the handset to ring during
do not disturb mode if the caller waits long
enough. After the selected amount of time
passes, the handset rings. If you select "No
Ringing", the handset never rings during do
not disturb mode.
1
MMENUN (right soft key) #239
2
MbN: Select the desired setting. a MOKN
a MOFFN
Note:
R When the answering system answers the
call, this feature does not work.
Selecting categories to bypass do
not disturb mode
1
MMENUN (right soft key) #241
2
MbN: Select the desired categories. a
MSELECTN
R " " is displayed next to the selected
category numbers.
R To cancel the selected category:
MbN: Select the category. a Press
MSELECTN again. " " disappears.
3
MOKN a MOFFN

Baby monitor

This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby's room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
R Before using this feature, we recommend
that you test this feature and adjust the
baby monitor sensitivity as needed,
especially if you plan to monitor from
outside.
R This feature should not be used as a
substitute for a medical or caregiver's
supervision. It is the caregiver's
36
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
responsibility to stay close enough to
handle any eventuality.
Note:
R Both the monitored and monitoring
handsets must select the same base unit in
order to use the baby monitor feature
(page 39).
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored.
If the base unit is placed near the
monitored handset, we recommend turning
off the base unit ringer volume (page 31).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby's room).
To monitor with a handset
The internal baby monitor feature is available
between handsets in the same radio cell.
1
MMENUN (right soft key) #268
2
MbN: "On" a MOKN
3
MbN: Select the desired handset number
to monitor with. a MOKN
R "Baby Monitor" will be displayed.
R The registered handset name/number
is displayed.
Note:
R When this feature is on, another handset
can hear the monitored handset by making
an intercom call.
To monitor from an outside line
If you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.