Advertisement
WARNING:
1. Maintain the heated desoldering gun carefully, the high
temperature gun will cause fires or painful burns to the body
if you are not careful.
2. Always disconnect the mains plug to a socket before any
maintenance performance except you do the solder waste
removing on the heater and nozzle.
Solder waste will be stored in the nozzle and heating element.
These solder waste will lower the heating
process and reduce the suction efficiency . Should there be a
noticeable drop in suction efficiency during
operation, please replace the filter and clean the nozzle and
heater with the cleaning pin .
Please follow below steps to remove the solder waste:
1. Pull the back holder, then the knob will bullet up and
become unlocked automatically .
2.Take the spring out from the glass tube ,then remove the
solder waste.
aluminum piece
filter
glass tube
Front Holder
3. Put the spring back to glass tube, then put glass tube back to
position.
www.tmatlantic.com
5
Advertisement
