Summary of Contents for Aktakom ASE-2105
- Page 1 User’s Manual Temperature Controlled Desoldering Station ASE-2105 Thank you for choosing AKTAKOM desoldering station. www.tmatlantic.com...
- Page 2 1. Description ASE-2105 designed for lead free desoldering especially. The quick heating and strong power are for convenient and clear soldering / desoldering all types of DIP components. Reasonable structure, single hand operation and strong absorbing power can be easy removal of the residual solder from the one-sided or two sided of the PCB.
- Page 3 2. Technical Specification STATION DESOLDER GUN INPUT 110-240VAC VOLTAGE VOLTAGE POWER POWER CONSUMPION HEAT UP RATING 200W MAIN FUSE 3.15A TEMPERTURE 160°C-480°C VACUUM 600mm Hg HEATING PTC CERAMIC PRESSURE ELEMENT HEATER 3. Operating Instruction 3.1 Place the desoldering gun in the holder separately. Then connect the plug to the station and turn clockwise to tighten the plug nut.
- Page 4 display. The set-point can be changed for ±1°C by tapping the “UP” or “DOWN” button. Pressing the button will change the set-point quickly. The digital display will return automatically to the actual value and the iron will reach to the setting temperature quickly.
- Page 5 WARNING: 1. Maintain the heated desoldering gun carefully, the high temperature gun will cause fires or painful burns to the body if you are not careful. 2. Always disconnect the mains plug to a socket before any maintenance performance except you do the solder waste removing on the heater and nozzle.
- Page 6 Press the back holder , then the knob will bullet down and become locked automatically. 4. Safety Instruction • The manufacturer assumes no liability for uses other than those described in the operating instructions or for unauthorized alterations. • The operating instructions and cautions should be read carefully and kept in an easily visible location in the vicinity of the control system.
- Page 7 • Advise other people in the work area that the unit can reach a very high temperature and should be considered potentially dangerous. • Turn off the power switch while taking breaks and when finishing using. • Before replacing parts or storing the system, turn off the power and let it cool down to the room temperature.
- Page 8 5.4 Maintenance Before further use, safety devices or slightly damaged parts must be carefully checked for error-free and intended operation. Inspect moving parts for error-free operation and that they don’t bind, or whether any parts are damaged. Damaged safety devices and parts must be repaired or replaced by a qualified technician, so long as nothing else is indicated in the operation manual.