Table of Contents
Advertisement
Troubleshooting
Reset to factory settings
Caution! The factory restore process will remove the Composer project.
To restore the controller for system recovery to the factory default image,
perform the following steps:
1 Insert one end of a paper clip into the small hole on the back of the
controller labeled FACTORY RESTORE.
2 Press and hold the FACTORY RESTORE button, the controller will reset and
the Caution LED will go solid red.
3 Hold the button until the Caution LED blinks double yellow. This should take
ive to seven seconds. The Caution LED will blink orange while the factory
restore is running. When complete, the Caution LED will turn of and the
device will reset to complete the factory restore process.
Power cycle the controller
Press the FACTORY RESTORE button for less than one second; do not hold it
down. The controller will reset.
Reset the network settings
To reset the controller network settings to the default, follow these steps:
1 Disconnect power to the controller.
2 While pressing and holding the ID button on the back of the controller,
power on the controller.
3 Hold the ID button until the Data, Link and Power LEDs are solid blue, then
immediately release the button.
4 If during the boot sequence the Caution LED stays orange, press and hold
the ID button until the LED blinks blue, and then release it.
Regulatory/Safety information
To review regulatory information for your particular Control4 products, see the
information located on the Control4 website at
www.control4.com/regulatory/
Warranty
Visit
www.control4.com/warranty
for details.
More help
For the latest version of this document and to view additional materials, open the
URL below or scan the QR code on a device that can view PDFs.
MOST RECENT VERSION
MORE INFO ON EA CONTROLLERS
ctrl4.co/ea1-ig
ctrl4.co/ea
.
control4.com | 888.400.4070
Copyright ©2015, Control4 Corporation. All rights reserved. Control4, the Control4 logo,
the 4-ball logo, 4Store, 4Sight, Control My Home, Everyday Easy, and Mockupancy are
registered trademarks or trademarks of Control4 Corporation in the United States and/
or other countries. All other names and brands may be claimed as the property of their
respective owners. All specifications subject to change without notice.
A
200-00378-A
2015-07-06 DH
Advertisement
Table of Contents
