Canon imageRUNNER C3222L Getting Started page 3

To connect via wireless LAN
1.
Make sure that the computer is connected to a
router properly.
2.
Check the network settings on the computer.
3.
Take note of the SSID and network key.
• Check the label on the router.
• The setting operation is easier if the router is
provided with a WPS mark.
4.
Set the access point and network key.
1. Select the access point (SSID).
2. Enter a network key, and select <Apply>.
• Wait until message <Connected.> is
displayed.
3. Select <Close>.
• The IP address will be automatically
confi gured in a few minutes.
5.
Install the driver and software.
P.4 "Installing the software"
Now you are finished with the
configuration of the initial settings.
User's Guide
User's Guide
For details
"Setting Up Using the Setup Guide" in the User's Guide
To connect via wired LAN
The machine does not come with a LAN cable.
Please have one ready, if necessary.
1.
Make sure that the computer is connected to a
router properly.
2.
Check the network settings on the computer.
3.
Connect the LAN cable.
• After connecting the cable, wait a few
minutes (until the IP address is set
automatically).
• If a static IP address has been set on the
computer, set the machine's IP address
manually.
4.
Install the driver and software.
P.4 "Installing the software"
Now you are finished with the
configuration of the initial settings.
Quick Setup
3