Manual Acknowledgement Of Duress; Configuration Command; Wiring Diagram - Beam RST410 Configuration Manual

Manual acknowledgement of duress
When using manual acknowledgment, ACK line on gateway relay interface is used
to detect and provide acknowledgement back to pendent.
Configuration commands
Step # Command
1 AT^DTRAUTOACK=n
2 AT^DTRPANICTIMEOUT=n
Where n is the number of seconds
(0-65535) n=0 disables the timeout
default value is 60
3 AT&W
Wiring diagram for Gateway Relay Interface
DB9 Pin Signal Name
100 VIN
101 GND
102 ACK
103 PANIC IN
105 PANIC OUT NC Normally closed contact for PANIC state controlled relay
109 #Sleep
Direction
Power supply Input 5-26V
Power Ground
Panic Acknowledgement input
Common contact for PANIC state controlled relay
Sleep Input. Pull to VIN to keep avoid unit going to low
power mode
www.beamcommunications.com
Description
When PANIC is received, ACK
line 102 is used to detect
acknowledgement
If this timeout is set, panic
indicating state of the Gateway
will be reset automatically if
no communication is detected
from the panic state triggering
Man Down Pendant.
Save settings
5