Window Installation Instructions; Preparing The Unit For Installation; Attach The Window Platform To The Window - EdgeStar Koldfront CAC10000W Owner's Manual

Window Installation Instructions

NOTE:
 These instructions are for installation in a standard slider or casement window only.
 If installing the unit into a casement window, open the window to the maximum amount to allow
for clearance of the cabinet.
 If the window cannot open more than 15 ½" for the cabinet to clear the window, the entire
window can be removed. If this is necessary, contact a professional to ensure proper
installation.
NOTE: When choosing your window, make sure power supply cord is within 6 feet of a grounded
3-prong outlet. Do not use an extension cord.

Preparing the Unit for Installation

Attach the Window Platform to the Window

1. Using the adjustment bolt and the hex flange nut, secure the platform support brace to the
window platform. Choose a slot for the adjustment bolt on both the platform and the
support brace that will create a 45° angle between the two pieces.
 Place the window platform assembly in the installation window to determine if the
 If the platform does not provide the proper slope, then move the adjustment bolt to
Note: If you are planning to use a siding protection board (step 5) on the outside of the house,
hold down the window platform flat while testing.
2. Measure 8 11/16" from the window jamb and lightly draw a line in pencil.
4
platform sits properly and will provide the proper slope (3/16" (~3°) lower on the
outside).
a different slot in the platform and support brace and test again.
A. Window platform
B. Hex flange nut
C. Platform support
brace
D. Adjustable bolt