Related Manuals for EdgeStar Koldfront WAC12000W
Summary of Contents for EdgeStar Koldfront WAC12000W
- Page 1 Window Air Conditioner and Heater WAC12000W Owner’s Manual For more information on other great EdgeStar products on the web, go to http://www.edgestar.com...
-
Page 2: Important Safety Information
Important Safety Information Improper handling can cause serious damage to the appliance and/or to the user. Please read the following safety information. Electrical Safety Make sure your hands are dry and not wet before operating the unit. Do not wet the front housing or control panel. ... - Page 3 2. Press the TEST button on the LCDI plug. This should trip the plug and cut the power to the air conditioner. If the plug does not trip and you are able to turn on the unit, please contact EdgeStar support. DO NOT USE YOUR WINDOW AIR CONDITIONER IF THE TEST FAILS.
-
Page 4: Table Of Contents
Error Codes ....................11 : ....................12 DDITIONAL REMOTE OPERATIONSMAINTENANCE ............13 ..................14 ILTER LEANING .................... 14 ABINET LEANING NORMAL SOUNDS ..................... 15 ENERGY SAVING GUIDE ................... 15 TROUBLESHOOTING ..................16 SPECIFICATIONS ....................18 EDGESTAR LIMITED WARRANTY ..............19... -
Page 5: Introduction
Introduction Thank you for purchasing this Koldfront by EdgeStar window air conditioner. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship. -
Page 6: Parts Identification
Parts Identification Louver Side View Control Panel Air Outlet Front Air Intake Panel Side and Back Vent Front View Top Channel CAUTION: Make sure the drain plug is firmly installed before using the unit to Side Curtains prevent leaking. Koldfront Window Air Conditioner... -
Page 7: Preparations For Installation
Preparations for Installation Tools Needed: NOTE: To avoid risk of injury and/or product/property damage, please take the following precautions: Flat Screwdriver Two or more people are needed to properly handle and install. Phillips Screwdriver Use proper lifting and carrying techniques. Tape Measure Before installation, make sure to inspect the window and sill are Level... -
Page 8: Window Installation Instructions
Window Installation Instructions Preparing the unit for window Installation NOTE: When choosing your window make sure Remove the Air Conditioner unit from Cabinet. power supply cord is within 4ft of a grounded 1. Remove the air conditioner from the carton and place 3-prong outlet on cardboard. -
Page 9: Attaching Foam Adhesive
4. To attach the side curtains to the air conditioner, insert the right-hand curtain connector tab into the curtain housing channels on the air conditioner. A. Side Curtain 5. Insert the top of the right-hand curtain housing to the top curtain channel as shown below: Top View: A. -
Page 10: Installing Cabinet Into Window
Installing Cabinet into Window NOTE: When choosing your window make sure power supply cord is Follow the steps listed below to install the cabinet into the window within 4ft of a grounded 1. Center empty cabinet into window: Check that lower rail of air conditioner cabinet is 3-prong outlet behind and against back side of window sill. -
Page 11: Attach Side Curtains To Window Frame
3. Check that the air conditioner cabinet is tilted back about 1 ⅛” to 1 ½“, which should be about 3-4 degrees downward to the outside. After proper installation, condensation should not drain from the overflow drain hole during normal use, correct slope or otherwise. -
Page 12: Completing Installation
Completing Installation 1. Insert the window sash seal (C) behind the top of the lower window sash and against the glass of the upper window (B). 2. Place the window-lock bracket (A) on top of lower window and against upper window sash on right side of the window. 3. -
Page 13: Control Panel Operations
Control Panel Operations On/Off Energy Saver Timer Mode Check Filter Fan Speed Sleep Temp/Timer Up Using the Control Panel Temp/Timer Down To Turn Unit on: Press On/Off Button. NOTE- The Energy Saver feature will automatically turn on in “Cool”, “Dry”, and “Auto” mode. To Change Temperature: Press or hold either Up or Down... -
Page 14: To Operate On Fan Only
Once the temperature you selected is achieved the unit will automatically maintain the room temperature. In this mode the fan speed cannot be adjusted. It will start automatically at a speed according to the actual room temperature. To operate on Fan Only: ... -
Page 15: To Check Filter Feature
Press or hold the Up or Down to change the Auto Time by ½ hour increments up to 10 hours or 1 hour increments up to 24 hours. The control will count down the time remaining until start. The selected time will register in 5 seconds and the system will automatically revert back to display the previous temperature setting or room temperature when the unit is on. -
Page 16: Additional Tips
Air Directional Louvers: The 4-way air directional louvers allow you to direct the air flow Up, Down, Left, and Right throughout the room as needed. To adjust the air directional louvers side to side use the center handles as you move side to side. Additional Tips: The “Cool”... -
Page 17: Remote Operationsmaintenance
Remote Operations MODE button- Press ON/OFF button- this button to select Select to turn unit desired operation off and on. mode from AUTO, COOL, DRY, HEAT, and FAN. TEMP UP button- Push this button to increase the MODE temperature setting in TEMP DOWN button –... -
Page 18: Air Filter Cleaning
Maintenance Clean the air conditioner and filters regularly to maximize performance and efficiency, and prolong the unit’s life. Be sure to always unplug the air conditioner from the power outlet before cleaning. Air Filter Cleaning The air filter should be checked at least once a month to see if NOTE: Winter Storage- cleaning is necessary. -
Page 19: Normal Sounds
Normal Sounds High Pitched Chatter- High efficiency compressors may have a high pitched chatter during the cooling cycle. Sound of Rushing Air- At the front of the unit, you may hear the sound of rushing air being moved by the fan. ... -
Page 20: Troubleshooting
Troubleshooting Follow the troubleshooting guide below to resolve common issues. Issue Possible Cause Solution My air conditioner is not Wall plug Make sure the unit is functioning at all disconnected plugged in. LCDI power cord is Press the Reset button tripped on the LCDI cord. - Page 21 Issue Possible Cause Solution Air conditioner is cooling Open doors, windows, Open = cold air but room is too warm, NO etc. escapes. Close doors, ice is forming on cooling windows, etc. coil behind decorative Unit recently turned on Allow additional time to remove “stored heat”...
-
Page 22: Specifications
Specifications Description of product Window Air Conditioner and Heater Model WAC12000W Voltage/Frequency 220V / 60Hz Input Power (cooling / heating) 1220W / 3500W Current (cooling / heating) 5.5A / 15.0A Color White Coolant R410A/17.64 Timer 24 Hour 22.6” x 23” x 16.1” Dimensions W x D x H Weight... -
Page 23: Edgestar Limited Warranty
EdgeStar authorized repair facility. PARTS: For a period of ONE (1) YEAR from the date of original purchase, EdgeStar will supply new, rebuilt, or refurbished parts free of charge. EdgeStar may request a defective part be returned in exchange for the replacement part. - Page 24 Register your product, download owner’s manuals, access additional troubleshooting resources, and obtain more information on other great EdgeStar & Koldfront products on the web at: http://www.edgestar.com Product contents and specifications may change without notice. Copyright © 2014 Living Direct, Inc.
Need help?
Do you have a question about the Koldfront WAC12000W and is the answer not in the manual?
Questions and answers