How To Manage: Error Codes - AEG BBB9000QB User Manual

Problems with Wi-Fi signal
Possible cause
New router installed or router configuration
changed.
The wireless network signal is weak.
The wireless signal is disrupted by a micro‐
wave appliance placed near the oven.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the oven system cannot connect with
the control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the oven functions will continue to work
as usually.
Code and description
F131 - the temperature of magnetron sensor is
too high.
F602, F603 - Wi-Fi is not available.
TROUBLESHOOTING
Remedy
To configure oven and mobile device again, re‐
fer to "Before first use" chapter, Wireless con‐
nection.
Move router as close to the oven as possible.
Turn off the microwave appliance.
Remedy
Check your network connection. Refer to "Be‐
fore first use" chapter, Wireless connection.
Turn the oven off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the oven off and on.
Remedy
Turn the oven off and wait until it cools down.
Turn the oven on again.
Turn the oven off and on.
35/48