FS AP-W6D1775C Quick Start Manual

FS AP-W6D1775C Quick Start Manual

Wi-fi 6 access point
Hide thumbs Also See for AP-W6D1775C:

Advertisement

Quick Links

ONFIRATION GUIDE
Wi-Fi 6 Access Point Reset and Recovery System Configuration Guide
Wi-Fi 6 Access Point Reset and
Recovery System Configuration Guide
Models: AC-224AP; AP-W6D1775C; AP-W6D2400C; AP-W6T3267C; AP-W6Q4134C; AP-W6T6817C;
AP-W6T10000C
www.fs.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AP-W6D1775C and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for FS AP-W6D1775C

  • Page 1 ONFIRATION GUIDE Wi-Fi 6 Access Point Reset and Recovery System Configuration Guide Wi-Fi 6 Access Point Reset and Recovery System Configuration Guide Models: AC-224AP; AP-W6D1775C; AP-W6D2400C; AP-W6T3267C; AP-W6Q4134C; AP-W6T6817C; AP-W6T10000C www.fs.com...
  • Page 2 1.3.3 Wireless Fat AP Password Recovery ................................2 2. Wireless Device Factory Reset ............................3 2.1 Networking Requirements ................................... 3 2.2 Network Topology ......................................3 2.3 Configuration Steps ...................................... 3 2.3.1 AC Controller Restore Factory Settings ................................. 3 2.3.2 Fat AP Factory Reset ...................................... 3 www.fs.com...
  • Page 3 1.3 Configuration Steps 1.3.1 U-boot Save Configuration and Reset Password Log in to the CLI interface of the switch, connect the console port of the switch with a console cable, open the hyper terminal CRT, and set related parameters. www.fs.com...
  • Page 4 4. Scattered utilities. ************************************************ Press a key to run the command: After entering the bootloader menu, enter ctrl+q at the same time, enter the uboot command line, in the uboot command line state, enter the command main_config_password_clear Bootloader # main_config_password_clear www.fs.com...
  • Page 5 (1)After the device is powered on and running normally, use a small broken needle, insert the reset hole and press for more than 3 seconds (generally press for 5-8 seconds), the device can automatically restore the factory settings. (2)Or log in to the AP device to use the command AP(config)apm factory-reset www.fs.com...
  • Page 6 S3910 SERIES SWITCHES DATASHEET www.fs.com...

Table of Contents