FS AC-224AP Configuration Manual
  1. Manuals
  2. Brands
  3. FS Manuals
  4. Wireless Access Point
  5. AC-224AP
  6. Configuration manual

FS AC-224AP Configuration Manual

Wireless devices reset and recovery system
Hide thumbs Also See for AC-224AP:
1
2
3
4
5
6
Table of Contents

Advertisement

Quick Links

Download this manual
Wireless Devices Reset And Recovery System Configuration Guide
WIRELESS DEVICES RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
Wireless Devices Reset and
Recovery System Configuration Guide
Models: AC-224AP; AP-W6T10000C; AP-W5T2600C
www.fs.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AC-224AP and is the answer not in the manual?

Questions and answers

Related Manuals for FS AC-224AP

Summary of Contents for FS AC-224AP

  • Page 1 Wireless Devices Reset And Recovery System Configuration Guide WIRELESS DEVICES RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE Wireless Devices Reset and Recovery System Configuration Guide Models: AC-224AP; AP-W6T10000C; AP-W5T2600C www.fs.com...
  • Page 2 1.3.3 Wireless Fat AP Password Recovery ................................2 2. Wireless Device Factory Reset ............................3 2.1 Networking Requirements ................................... 3 2.2 Network Topology ......................................3 2.3 Configuration Steps ...................................... 3 2.3.1 AC Controller Restore Factory Settings ................................. 3 2.3.2 Fat AP Factory Reset ...................................... 3 www.fs.com...
  • Page 3 1.3 Configuration Steps 1.3.1 U-boot Save Configuration and Reset Password Log in to the CLI interface of the switch, connect the console port of the switch with a console cable, open the hyper terminal CRT, and set related parameters. www.fs.com...
  • Page 4 Press a key to run the command: Press Ctrl+q, enter main_config_password_clear, and wait for the device to restart before proceeding to the device AC-224AP#main_config_password_clear Note: After entering the CLI command line interface, if there is no button, the password is required when entering again. The default timeout is 10min, please change the password in time before timeout.
  • Page 5 (1)After the device is powered on and running normally, use a small broken needle, insert the reset hole and press for more than 3 seconds (generally press for 5-8 seconds), the device can automatically restore the factory settings. (2)Or log in to the AP device to use the command AP(config)apm factory-reset www.fs.com...
  • Page 6 Copyright © 2009-2020 FS.COM AII Rights Reserved.

This manual is also suitable for:

Ap-w6t10000cAp-w5t2600cAp-w6t6817cAp-w6d2400c108706108704 ... Show all

Table of Contents