Number Of Ts0S; Data; Cts; Dcd - ADTRAN ESU LT User Manual

Number of TS0s

Data

CTS

DCD

DSR

Conditions which cause the Port Control Signals to be deactivated
SIGNAL RTS
CTS Follows OFF
DCD —
DSR —
Where " — " = don't care
61200410L1-1B
Used to select the number of time slots to be used. The DTE
rate will be this number times 56K or 64K, depending on the
TS0 rate setting (see DTE Data Rate Chart on page 67). This
option setting is ignored in unframed mode since all time
slots are automatically used.
Choices: CCS mode (01 to 31);
CAS mode (01 to 30)
Used to control the inverting of the DTE data. This inversion
can be useful when operating with an HDLC protocol. This is
often used as a means to ensure ones (1s) density. ESU LTs on
both ends of the circuit must have this option configured the
same way. This option is ignored in unframed mode.
Choices: N
ORMAL
Used to control characteristics of CTS.
Choices: N
ORMAL
Data Carrier Detect - Indicates to the DTE when a valid
signal is being received at the Network Interface.
Choices: N
ORMAL
Data Set Ready - This signal indicates to the DTE when the
DCE is turned O
Choices: N
ORMAL

Table 5-1. Normal Mode Operation for Port Control Signals

NORMAL MODE OPERATION
V.54 511
LOOP BK TST ON
OFF
— —
OFF OFF
; I
NVERT
(see Table 5-1); F
(see Table 5-1); F
and ready for operations.
N
(see Table 5-1); F
SELF-TEST NETWK TEST
ACTIVE ACTIVE
OFF OFF
OFF —
OFF OFF
ESU LT User Manual
Chapter 5. Configuration Menu
O
ORCE N
O
ORCE N
O
ORCE N
NO TS0
MAPPED
OFF
OFF
OFF
NETWORK
ALARM
OFF
OFF
—
51