Eizo FlexScan S2001W User Manual page 35

Color lcd monitor
Hide thumbs Also See for FlexScan S2001W:
Table of Contents

Advertisement

Movable range
Tilt
Swivel
Adjustable
height
Rotation
Environmental
Temperature
Conditions
Humidity
USB
Standard
Port
Supply current
S2201W
LCD Panel
Dot Pitch
Horizontal Scan Frequency
Vertical Scan Frequency
Resolution
Max. Dot Clock
Max. Display Color
Display Area (H × V)
Power Supply
Power
Screen Display On
Consumption
Power saving mode 1W or less (for single signal input, without USB load, when stereo mini jack
Power button Off
Input Signal Connector
Analog Input Signal (Sync)
Analog Input Signal (Video)
Digital Signal Transmission System
Video Signal Memory
Audio Output
Line input
*
LCD Module characteristics only
Height adjustable stand
EZ-UP stand
Height adjustable stand
EZ-UP stand
Height adjustable stand
EZ-UP stand
Height adjustable stand
EZ-UP stand
Operating temperature: 0 °C - 35 °C
Storage temperature: -20 °C - 60 °C
Relative humidity: 30% - 80% (no condensation)
USB Specification Revision 2.0
Upstream port × 1, Downstream port × 2
Downstream: Max. 500mA/1 port
22.0-inch (560 mm) TFT color LCD with anti-glare hard coating
Viewing angle*: Horizontal 170°, Vertical 160° (CR:10 or more)
0.282mm
Analog: 24-82kHz
Digital: 31-65kHz
Analog: 49-86Hz (Non-interlace)
(1280 × 1024: 49-76Hz)
(1680 × 1050: 49-61Hz)
Digital: 59-61Hz (Non-interlace)
(VGA TEXT: 69-71Hz)
1680 dots × 1050 lines
Analog: 150MHz
Digital: 120MHz
Approx. 16.77 million colors: Applicable to 8 bit (1048.77 million colors)
473.8mm × 296.1mm
100-120 VAC ±10%, 50/60Hz 1.0A
200-240 VAC ±10%, 50/60Hz 0.6A
60W or less (with USB load, when stereo mini jack is connected)
50W or less (without USB load, when stereo mini jack is not connected)
is not connected)
0.7W or less (without USB load, when stereo mini jack is not connected)
DVI-I connector (Applicable to HDCP), D-Sub mini 15-pin
Separate, TTL, positive/ negative
Composite, TTL, positive/ negative
Analog, Positive (0.7Vp-p/75Ω)
TMDS (Single Link)
Analog signal: 45 (preset: 24)
Digital signal: 10 (preset: 0)
Speaker output: 0.5W + 0.5W (8Ω, THD: 10% or less)
Headphone output: 2mW + 2mW
Input impedance : 47 kΩ (typ.)
Input level :1.0 Vrms (Max.)
: 40° Up, 0° Down
: 25° Up, 0° Down
: 35° Right, 35° Left
: 172° Right, 172° Left
: 82 mm
: 165 mm
: 90°
: 90°
Chapter 5 Reference
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Flexscan s2201w

Table of Contents