Sekonic LITEMASTER PRO Service Manual page 14

・When attaching a PCB / 3 Assembly, it is cautious of the four following points, and is a screw stop.
1)Wire Harness / 1 (JR109001:white), and Wire Harness / 2 (JR109002:blue) are twisted 6 times.
2)Wiring of Wire Harness / 1 , and Wire Harness / 2 lets between the ribs of a PCB / 3 Assembly of
battery case pass through between two ribs of a Main Frame Cover / F Assembly.
3)It attaches so that a PCB / 3 Assembly of substrate may come below the convex part of a power
switch.
4)The side of a Main Frame Cover / F Assembly is extended, and the portion of the nail of a PCB / 3
Assembly of battery case is hooked.
2)It lets between two ribs pass.
1)It twists 6 times.
Wire Harness / 1 (JR109001:white)
Wire Harness / 2 (JR109002:blue)
3)The power switch of the PCB / 3 Assembly.
3)power switch
Since a PCB /3 Assembly will hit
a power button if a PCB / 3
Assembly is taken down straight,
vehicle warehousing is carried
out.
・ If the screw stop of the PCB / 3 Assembly (JR10-903) is carried out, please check a bite lump of Wire
Harness / 1 (JR109001:white) and Wire Harness / 2 (JR109002:blue) and a feeling of a click of a
power button.
Wire Harness should move without load.
It bites, when there is load.
Push a power button and there needs to be a
feeling of a click.
When there is nothing, the tip of a power button
may be under a substrate.
A power button should be on a PCB / 3.
3)PCB / 3 Assembly
4)The nail of the battery case should be caught in
the Main Frame Cover / F Assembly.
14
2)It lets between the ribs of a
PCB / 3 Assembly of battery
case pass.