Adjustment Of The Knee Lifter Lever - Pfaff hobby GrandQuilter 1200 Manual

Adjustment of the knee lifter lever

Requirement
When the presser foot is fully raised with the knee lifter, the clearance between the needle plate and presser
foot must be 7.5 mm
Adjustment
• Lay the machine on its back.
• Remove the base
• Loosen the nut (A) on the knee lifter lever (B) slightly and turn the adjusting screw (C) to adjust the height.
• If it is lower than 7.5 mm, turn the adjusting screw (C) clockwise.
• If it is higher than 7.5 mm, turn the adjusting screw (C) counterclockwise.
• Tighten the nut (A) fi rmly and attach the base.
• Lower the needle bar to the lowest position
• Check so the needle cramp does not hit against the presser foot when it is fully raised.
12
(A)
7.5 mm
(B)
(C)
104 72 63-26