Advertisement
ddrum4 SE V1.5x
Values: OFF, 1.00 - 2.00.
O O O O
B B B B
U U U U T T T T
Here you can assign and set the panning of a channel to the outputs B3, B4, B5 and B6.You could con-
sider this function a pan control between four outputs rather than the normal two. If e.g. you would like
to send one channel to a separate input on a mixer, set Out A of that channel to OFF, raise the Level B
parameter (see
page
corresponds to output B3 only, a value of 3.50 makes the channel present equally in both of the B3 and
B4 outputs, a value of 4.00 is output B4 only etc. (see the figure below). Change the pan setting for each
channel with the R
Values: OFF, 3.00 - 4.00 - 5.00 - 6.00
N N N N
# # # #
O O O O T T T T E E E E
Here you can set the MIDI Note number that each channel is transmitting and responding to. MIDI
Note number 60 (middle C) is equivalent to C4 in the ddrum4. If you press the Shift button, you will
27) to anything above 0 and set the Out B parameter to any integer. A value of 3.00
D
.
OTARY
IAL
6. Panel reference: System functions
Page 21
Advertisement
