Advertisement
ddrum4 SE V1.5x
L L L L
B B B B
E E E E V V V V E E E E L L L L
This sets the level of the selected sound in the four alternate outputs B3-B6. Set the level with the R
D
. Note that a sound can be present at both the A and the B outputs at the same time.
TARY
IAL
Note! The total level of the B3-B6 outputs are NOT affected by the M
fected by the MIDI Volume setting described on
Values: 0 - 100
S S S S
H H H H I I I I F F F F T T T T F F F F U U U U N N N N C C C C T T T T I I I I O O O O N N N N S S S S
To access the shift functions you should press and hold the S
function buttons.
The ddrum4 SE has a large sound memory. When the ddrum4 SE is shipped from factory it's loaded
with the ddrum4 SE factory sounds. Most of the shift functions are related to sound and memory man-
agement including erasing and replacement of sounds.
IMPORTANT! It's very important to understand that the entire sound memory including the factory
sounds can be erased and replaced with other sounds. There are no factory sounds that cannot be re-
moved or replaced. This sets a new standard of flexibility but it presents a potential problem; the un-
intended erasing of sounds, or the entire sound memory. After such an operation, you would need to
reload the ddrum4 SE with sounds in order to be able to use it again. We have made it a bit difficult
to erase the memory but please read the following paragraphs before you start to experiment with these
functions. Another good thing to do is to download the factory sounds from our web site at http://
www.clavia.se/ as a precaution.
6. Panel reference: Shift functions
ASTER
page
22.
button and then press any of the sound
HIFT
-
O
L
setting but IS af-
EVEL
Page 27
Advertisement
