Using Your Ageloc Lumispa Device - ageLOC LumiSpa User Manual

USING YOUR AGELOC® LUMISPA®
ageLOC LumiSpa is a twice daily regimen. Use it morning and night for best results.
STEP 1
• Moisten face with water.
• Apply ageLOC LumiSpa treatment cleanser to
all areas of the face, avoiding the eyes and lips.
STEP 2
• Wet treatment head by placing it under running
water. Then turn on the device by pressing the On/
Off button.
• Each of the four lights around the center button
will flash once and the treatment head will
immediately begin to counter-rotate—first slowly
then up to normal speed.
• Gently glide the treatment head back and forth in
slow, broad strokes over one of the areas of your
1
face. If you use a scrubbing motion or press too
2 3
hard, the device will pause and vibrate to
4
you to apply normal pressure and resume slow,
broad strokes.
• The device will pause briefly three times (once
every 30 seconds) to prompt you to move from
one area of the face to the next.
STEP 3
• When the treatment is done, the device will stop.
• The device will turn off automatically.
• Rinse your face with water to remove residual
treatment cleanser.
remind
9