AQUAMAXX FR-S Installation Manual

FR-S / FR-M
Please open the package carefully, and check
1
if there's any damaged or missing part.
FR-S
(1) Main media reactor body and lid
(2) Pump: Sicce Syncra Nano
(3) Sponges *4
FR-M
(1) Main media reactor body and lid
(2) Pump: Sicce Micra
(3) Sponges *4
You can change the order of the sponges depends
on media size. Original setting (top-bottom):
coarse - fine - fine - coarse
To fill in the media:
7
(1) Turn counterclockwise to release the lid
Select a suitable place to set your media reactor:
8
(1) The pump must be completely submerged underwater when in use.
(2) Attachment with a magnet holder for a glass thickness up to 10mm (3/8")
Put the wire here
Internal GFO Carbon and Biopellet Filter Media Reactor
While we take great care to keep any contaminants away from our products during assembly, please take a
2
moment to clean with warm water ONLY. Never clean Acrylic with alcohol-based products. Use caution when
handling acrylic scratches easily.
Some media (such as phosphate control products) is not designed to be aggressively fluidized in a reactor –
3
please read the instructions for your media carefully.
Wash your media before you use it. It is recommended that biopellets are soaked for 24 hours in aquarium
4
water before use. Start with 25% of the total amount of biopellets then add 25% more weekly.
Biopellets may initially clump during break-in. Turn off the pump and allow the clumps to settle at the bottom
5
of the reactor. Gently shake the reactor to break up clumps. Once the pellets go through this initial break-in
process, they generally require no further action.
For media designed to be fully fluidized, the reactor should be filled no more than two-thirds full to allow
6
the media room to move around. With heavy or fine media, you may need to add less.
(2) Pick up the upper sponges to fill in the media.
Please discard the
cardboard between the
magnets before use.
Make sure
the O-ring is
in position.
(3) Put back the sponges.
(could be skipped for Biopellet)
Sponges are not
necessary for Biopellet,
if you are going to use
Biopellet, you can pick
up all the sponges.
To Start
9
(1) Set the flow control on the pump to its lowest setting.
(2) Plug in the pump. Adjust the flow rate with the input control dial.
TO AVOID DANGER,
KEEP THE POWERFUL
MAGNETIC MOUNT -
AWAY FROM BABIES
AND CHILDREN.
www.aquamaxxaquariums.com
info@aquamaxxaquariums.com
(4) Turn clockwise to tighten the lid.
Do not over-tighten.
+
- +
FR-S
FR-M