Table of Contents
Advertisement
from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some
water before using the steam mop.
STEAM CLEANING
• Place a cleaning pad (6) on the floor with the 'hook & loop' side facing up.
• Lightly press it down onto the cleaning pad.
• Plug the steam mop electric cord into the outlet.
• Press the ON/OFF button (1). It takes approximately 15 seconds for the steam mop to heat up.
• Press the SmartSelect
• Pulling the handle tube
steam will start to come out of the steam head.
NOTICE:
If the system has been run dry it may take up to 30 seconds to prime the
system on first use.
• It takes a few seconds for steam to enter the cleaning pad. The steam mop will now
glide easily over the surface to be sanitized/cleaned.
• Push and pull the steam mop slowly across the floor to thoroughly steam clean each section.
NOTICE:
During use you may turn off the steam pump by returning the handle to the
upright position, this convenient feature will allow you to put the steam mop down for a
short time so that you may move items of furniture, then continue cleaning without the
need to switch the appliance off.
AFTER USE - Fig. K
• Return the handle tube (4) to the upright
position and turn the steam mop 'OFF'.
• Wait until the steam mop cools down.
(approximately five minutes)
• Unplug the steam mop from the wall outlet.
• Empty the water tank (3).
• Remove the cleaning pad (6) and wash it so
that it is ready for the next use. (Take care
to follow the wash care
on the cleaning pad).
• Wrap the electric cord around the cord hooks (21 & 22).
NOTICE:
The top cord hook rotates to easily release the cord ready for next use.
NOTICE:
With the handle tube in the upright position, the cord neatly wrapped
around the cord hooks, your steam mop will stand on its own for storage. Alternatively
there is a hanging bracket built into the hand grip which will allow your steam mop to be
hung from a suitable hook on the wall. Always ensure that your wall hook is capable of
supporting the weight of the steam mop safely.
Your BLACK+DECKER corded appliance has been designed to operate over a long
period of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper appliance care and regular cleaning.
WARNING:
switch off and unplug the appliance.
• Clean your appliance using a soft damp cloth. Never let any liquid get inside the
appliance; never immerse any part of the appliance into a liquid. IMPORTANT: To
assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
• For stubborn marks you can use a mild solution of soap and water to dampen your cloth.
CARE OF THE CLEANING PADS
NOTICE:
Follow the cleaning instructions printed on the label of your cleaning pad.
Wash care instructions - Machine wash warm 140°F (60°C) - No bleach - No fabric
softener - Air dry only - Allow to dry fully before re-use.
button (2) until the required setting is reached.
TM
(4) back will activate the steam pump. After a few seconds
instructions printed
MAINTENANCE AND CLEANING
Before performing any maintenance or cleaning on corded appliances
K
8
Advertisement
Table of Contents
