Hints For Optimum Use; Steam Cleaning - Black & Decker BDH1760SM Instruction Manual

GENERAL USE
CAUTION:
Never use the steam mop without first attaching a cleaning pad.
CAUTION:
It is important to monitor the water level in the water tank. To refill the
water tank and continue to sanitise/ clean, return the handle tube (4) to the upright
remove and refill the water tank (3).
CAUTION:
Never leave the steam mop in one spot on any surface for any period of
time. Always place the steam mop on the resting mat (7) with the handle tube in the upright
position when stationary and make sure the steam mop is turned off when not in use.
slowly, covering a small area at a time.
from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some
water before using the steam mop.

STEAM CLEANING

Raise the steam mop off the resting mat (7) and lightly press it down onto the cleaning pad.
heat up.
SmartSelect
steam will start to come out of the steam head.
NOTICE:
If the system has been run dry it may take up to 30 seconds to prime the
system on first use.
glide easily over the surface to be sanitized/cleaned.
Push and pull the steam mop slowly across the floor to thoroughly steam clean each section.
NOTICE:
During use you may turn off the steam pump by returning the handle to
the upright position, this convenient feature will allow you to place the steam mop on
the resting mat for a short time so that you may move items of furniture, then continue
cleaning without the need to switch the appliance off.
down. (approximately five minutes)
CARPET REFRESHING
CAUTION:
It is important to monitor the water level in the water tank. To refill the water
tank and continue to sanitize/ clean, return the handle tube (4) to the upright position and turn
supplied water jug.
CAUTION:
Never leave the steam mop in one spot on any surface for any period
of time. Always place the steam mop on the resting mat (7) with the handle tube in the upright
position when stationary and make sure the steam mop is turned off when not in use.
SmartSelect
will start to come out of the steam head.
Push and pull the steam mop slowly across the carpet to thoroughly refresh each section.

HINTS FOR OPTIMUM USE

TM
button (2) until the required setting is reached.
TM
8
To remove stubborn stains