Table of Contents
Advertisement
en Troubleshooting
Fault
"E:10 / -00 / -10 / -20"
"E:60 / -2B"
"E:35 / -10"
58
Cause
The pump for the intelligent
dosing system is blocked.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
The water pressure is low.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
There is water in the base
trough.
The appliance is leaking.
The detergent drawer has
not been pushed in as far as
it can go.
The pump unit is not inser-
ted.
troubleshooting
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer",
Page 50
If this indicator appears again, call
3.
our after-sales service.
→ "Customer Service", Page 68
Note: You can start the washing pro-
gramme if you deactivate the intelli-
gent dosing system and dose manu-
ally.
→ "Buttons", Page 25
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
No remedial action possible.
"Clean the water inflow filter"
▶
→ Page 55.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 68
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 68
Push the detergent drawer in as far
▶
as it will go.
Insert the pump unit into the deter-
1.
gent drawer.
→ "Cleaning the detergent drawer",
Page 50
Push the detergent drawer in as far
2.
as it will go.
Advertisement
Table of Contents
