Deactivating Wi-Fi On The Appli- Ance; Software Update; Resetting The Appliance Network Settings; Remote Diagnostics - Siemens WM6HXKE0DN User Manual And Assembly Instructions

Deactivating Wi-Fi on the ap-
pliance
Press and hold
1.
three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press repeatedly until the dis-
3.
play shows OFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.

Software update

Requirement: The display shows
UdP.
Press and hold
1.
seconds.
Set the programme to position 6.
2.
a UPd appears on the display.
Press .
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance net-
work settings
Press and hold
1.
3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press .
3.
a The display shows .
Press .
4.
a The network settings are reset.
for at least
for approx. 3
for at least
a If End is shown on the display, the
network settings are reset.
Tip: If you wish to operate your appli-
ance again via the Home Connect
app, you will need to reconnect it to
the Wi-Fi and to the Home Connect
app.

Remote diagnostics

Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com

Data protection

Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
Home Connect en
47