Advertisement
Assembly & Installation
Installing the Bagger Assembly
To Install the bagger mounting bracket, follow these steps:
1.
Remove, and discard, the four self-tap bolts on the rear
frame of the tractor, as shown in Figure 4-1.
2.
Install the bagger mounting bracket on the tractor, using
four 710-1260A hex bolts from hardware pack 683-05147.
Feed each hex bolt through the tractor frame, the rear
hood mounting tube, and thread into the weld-nut on the
bagger mounting bracket, as shown in Figure 4-2.
8
Figure 4-1
Figure 4-2
3.
Install the grass-bag mounting assembly onto the bagger
mounting bracket by lowering it down (1) and fitting the
assembly into the slot provided in the mounting bracket.
See the Inset in Figure 4-3.
4.
Secure the grass-bag mounting assembly to the bagger
mounting bracket using the attachment knob (720-04061)
found in the hardware pack (683-05147). See (2) in Figure 4-3.
2
Figure 4-3
5.
Remove the protective caps on the bagger cover hood
mounting threads and attach the bagger hood over the
grass-bag mounting assembly as shown in Figure 4-4. Align
the tabs on the hood into the slots on the grass-bag mounting
assembly. Secure the bagger hood using two flange lock nuts
(712-04150) included in the same hardware pack.
Figure 4-4
4
1
Advertisement
