Assembly & Installation - MTD 19A30011OEM Operator's Manual

Assembly & Installation
Installing the Bagger Assembly
To Install the bagger mounting bracket, follow these steps:
1. Remove, and discard, the four self-tap bolts on the rear
frame of the tractor, as shown in Fig. 4-1.
2. Install the bagger mounting bracket on the tractor, using
four 710-3015 hex bolts from hardware pack 689-00210.
Feed each hex bolt through the tractor frame, the rear
hood mounting tube, and thread into the weld-nut on the
bagger mounting bracket, as shown in Fig. 4-2.
8
Figure 4-1
Figure 4-2
3. Install the grass-bag mounting assembly onto the bagger
mounting bracket by lowering it down (1) and fitting the
assembly into the slot provided in the mounting bracket.
See the Inset in Fig. 4-3.
4. Secure the grass-bag mounting assembly to the bagger
mounting bracket using the attachment knob (720-04061)
found in the hardware pack (689-00210). See (2) in Fig. 4-3.
2
Figure 4-3
5. Attach the bagger hood over the grass-bag mounting
assembly as shown in Fig. 4-4. Align the tabs on the hood
into the slots on the grass-bag mounting assembly. Secure
the bagger hood using two flange lock nuts (712-04150)
included in the same hardware pack.
Figure 4-4
4
1