Figure 45. Pull out two removable tapes
Step 6.
Carefully lift the LCD panel, detach the EDP cable connector from the panel, and then remove the
LCD panel.
Figure 46. Detach the EDP cable connector and remove the LCD panel
Refer to "LCD FRUs and CRUs" on page 28 to look up details about the following replacement parts:
LCD bezel
Hinge cover
Hinges
Removable tapes
LCD panel
Remove the camera board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 32
"Remove the battery pack" on page 33
"Remove the upper case (with keyboard)" on page 43
.
Chapter 4
Removing a FRU or CRU
53