Panasonic SC-TMAX40 Operating Instructions Manual page 17

Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [SELECT] repeatedly on the unit to select "AUX".
█ To set the code to "REMOTE 2"
1 Press and hold [SELECT] on the unit and [<] until
"REMOTE 2" is shown.
Press and hold [OK] and [<] for a minimum of
2
4 seconds.
█ To set the code to "REMOTE 1"
1 Press and hold [SELECT] on the unit and [
the remote control until "REMOTE 1" is shown.
2 Press and hold [OK] and [
control for a minimum of 4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1 Press and hold [1] on the unit until "RESET?" is
shown.
2 While you press and hold [1] on the unit, press
[SELECT].
"RESET" is shown.
After "– – – – – – – – –" is shown, the unit will switch
off automatically.
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
DEMO play
The unit will play built-in demonstration song for 1 minute.
1 Press and hold
"WAIT FOR DEMO PLAY" is shown while you press
and hold the button.
Demonstration song is played and "DEMOPLAY" is
shown.
Press [8] to stop the demonstration song.
2
] on the remote
for more than 2 seconds.
] on
17