Mercedes-Benz A-Class Operator's Manual page 279

Pull plug 7 with the cable and ller hose
#
out of the tire in ation compressor housing.
Insert tire sealant bottle 9 in socket
#
the tire in ation compressor in such a way
that the red arrow on tire sealant bottle
matches the red arrow on the tire in ation
compressor.
Turn tire sealant bottle
#
clockwise.
Insert the plug of ller hose
#
of tire sealant bottle 9.
Turn ller hose 3 a quarter turn clockwise.
#
3
Remove the valve cap from valve
#
faulty tire.
6 of
Screw union nut 4
#
9
valve A.
Insert plug 7 into a 12 V socket in your vehi-
#
cle.
Turn the key to position 1 in the ignition lock.
#
9 a quarter turn Press on and o switch
#
compressor.
The tire in ation compressor is switched on.
3 in socket 5
The tire is in ated. First, tire sealant is pum-
ped into the tire. The pressure may brie y rise
to approximately 500 kPa (5 bar/73 psi).
Do not switc Do no t switch h o o t t he tir
during t dur ing this phase!
Let the tire in ation compressor run for a max-
#
imum of ten minutes.
The tire should then have attained a tire pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tire sealant leaks out, make sure you clean the
a ected area as quickly as possible. It is prefera-
ble to use clean water.
A on the
If you get tire sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
of ller hose 3 onto
If, If, a er a er t t en minut
(2.0 bar/29 psi) has no (2.0 bar/29 psi) has not been att
Switch o the tire in ation compressor.
#
Breakdown assistance 277
8 on the tire in ation
he tire e in ation in ation com compr pressor essor
his phase!
en minutes, a tir es, a tire pr e pressur essure of 200 kPa e of 200 kPa
t been attained: ained:
277