Table of Contents
Advertisement
Destination
The network address of destination LAN.
LAN IP
Subnet Mask The subnet mask of destination LAN.
The next stop gateway of the path toward the destination
Default
LAN. This is the IP of the neighbor router that this router
Gateway
should communicate with on the path to the destination LAN.
The number of hops (routers) to pass through to reach the
Hop Count
destination LAN.
Interface
The interface that go to the next hop (router).
Fill in the "Destination LAN IP", "Subnet Mask", "Default
Gateway", "Hop Count" and "Interface" of the rule to be
added and click "Add". Then this static routing rule will be
Add a Rule
added to the "Static Routing Table" listed below. If you found
any typo before adding it and want to correct it, just click
"Reset" and the fields will be cleared.
If you want to remove some routing rules from the "Static
Routing Table", select the rules you want to remove in the
Remove a
table and click "Delete Selected". If you want remove all
Rule
rules from the table, just click "Delete All" button. Click
"Reset" will clear your current selections.
Click <Apply> at the bottom of the screen to save the configurations. You can
now configure other advance sections or start using the router.
75
Advertisement
Table of Contents
