Table of Contents
Advertisement
20
THE PROTECTOR SYSTEM
NOTE: This accessory must be used for all installations
where the closing force as measured on the bottom of the
door is over 400 N (40 kgf).
SPECIAL NOTE: Merlin strongly recommends that The
Protector System
(IR Beams) be installed on all garage
TM
door openers.
IR BEAMS: By installing IR Beams, an open door is prevented
from closing if a person or object is located in the beam area. If
the door is already closing, it will return to the open position. A
closed door is not prevented from opening.
If the Protector System
TM
be removed, the opener will need to be reprogrammed (refer to
paragraph 4 of the troubleshooting section).
Whilst Merlin have engineered safety features into your garage door opener, we urge you to consider fitting The Protector
™
System
(IR Beams) to your new garage door opener. In many countries these devices are compulsory to assist in preventing
serious injury or property damage. For your own peace of mind and the safety of others please install this inexpensive safety
device.
21
PROGRAM TRANSMITTERS TO THE OPENER LIGHT
To Program your transmitters to operate your garage door opener light follow the below steps:
1.Press and release the "LEARN" button, and the "courtesy light" will flash twice (fig.1).
2.Press and release the "PROG" button and the garage door opener will go into
Courtesy Light learn mode for 30 seconds (fig.2).
3.Press any transmitter button (fig.3) to learn this button to the garage door opener
courtesy Light, the garage door opener "courtesy Light" will flash twice.
NOTE: Do not use the same transmitter button that has been previously
learned to the garage door opener for operation.
The transmitter is now learnt to the garage door opener courtesy Light.
To Erase all Transmitter Codes
1.Press and hold the "LEARN" button on the opener until the courtesy light flashes
twice, and continue holding for approximately 8 seconds, until the courtesy light
flashes twice again.
2.Release the button, all codes are now erased.
TM
(IR BEAMS) (OPTIONAL)
(IR Beams) is installed and needs to
To prevent entrapment, install The Protector
System™ (IR Beams) no higher than 100 mm above
the floor.
Disconnect power to the garage door opener
before installing The Protector System™(IR Beams)
SAFETY FIRST!
13
fig.1
Indicator LED
fig.2
Indicator LED
fig.3
Advertisement
Table of Contents
