Table of Contents
Advertisement
Problem
and a number come on. There is an error in the
comes on.
There is no spark when
you try to activate the
spark generator.
The flame extinguishes im‐
mediately after ignition.
The flame ring is uneven.
Possible cause
The diameter of the bottom
of the cookware is too
small for the zone.
hob.
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating pro‐
tection for the zones oper‐
ate.
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is released.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heat‐
ed up sufficiently.
Burner crown is blocked
with food residues.
ENGLISH
Remedy
Use cookware with correct
dimensions.
Refer to "Technical infor‐
mation" chapter.
Disconnect the hob from
the electrical supply for
some time. Disconnect the
fuse from the electrical
system of the house. Con‐
nect it again. If
comes
on again, speak to an Au‐
thorised Service Centre.
Deactivate the hob. Re‐
move the hot cookware.
After approximately 30
seconds, activate the zone
again. If the cookware was
the problem, the error mes‐
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati‐
ble with the hob.
Refer to "Hints and tips"
chapter.
Check if the hob is correct‐
ly connected to the electri‐
cal supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse releases
again and again, contact a
qualified electrician.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec‐
onds.
Make sure that the injector
is not blocked and the
burner crown is clean.
17
Advertisement
Table of Contents
