Electrolux EGD6576 User Manual page 16

16 www.electrolux.com
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Heat Up func‐
tion does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
comes on.
Possible cause
You touched 2 or more
sensor fields at the same
time.
STOP+GO function oper‐
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
Power management func‐
tion operates.
The cookware is too large
or you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
Remedy
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor
field.
Refer to "Daily use" chap‐
ter.
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Refer to "Daily use" chap‐
ter.
Put large cookware on the
rear zones if possible.
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use" chap‐
ter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.