EVGA Z270 FTW-K Initial Installation page 98

EVGA Z270 FTW – K (132-KS-E277)
3. Once you have verified there are no detection/driver
installation issues with the cards you can enable SLI.
Right-click on the desktop and select "NVIDIA Control
Panel" ("NCP").
Next, select "Configure SLI, Surround, PhysX" under the
"3D Settings" menu. The default is "Disable SLI."
To enable SLI, click "Maximize 3D Performance," circled in
red below, and click "Apply" at the bottom.
Before you can enable SLI, the NCP may ask you to close certain programs and
processes; you cannot continue further until this is completed.
At this point the display may go black a few times, or appear to change resolution and
back again quickly; this is normal. Also, if you are running a G-Sync monitor, it will turn
off and on during this process, which may take approximately 5 and 20 seconds.
- 98 -