Assembly Steps - modway EEI-3836 Instruction Manual

EEI-3836 CHAIR
STEP 1:
1. Take out the Chair Body (1), Base (2) and hardware package from the carton.
2. Please put Chair Body (1) upside down on a carpeted or padded surface.
3. Adjust and match 4 holes of the bottom of Chair Body (1) and Base (2) ,then insert 1 piece of Bolt (A) with 1
piece of Spring Washer (B) & 1 piece of Flat Washer (C) into one of the matched holes in the bottom of Chair
Body (1) and Base (2) but don't fully tighten at this step. Repeat the same steps for other 3 holes.
4. Tighten all Bolts (A) by using Allen Wrench (D) fully.
STEP 2:
Carefully turn over the assembled Chair.
Assembly is complete. Your Chair is ready to enjoy now!
Customer Service 908-368-1025︱www.modway.com
Page 2 of 2