Smart Operation - Whirlpool Cabrio WED8000D Operator's Manual

Using Your Dryer — Smart Operation
NOTE: You must have successfully completed the "Connectivity Setup" section on pages 10 and 11 for the following features
to function. Verify that the Wi-Fi status indicator (
including Delay Start.
Download a Specialty Cycle
or My Cycle
The Download & Go™ option lets you select and send a
Specialty Cycle or My Cycle from the Whirlpool™ app directly
to your dryer. The indicator above Download & Go will illuminate.
Touch DOWNLOAD & GO to select the cycle. The Time/Status
display will show the estimated cycle time. Touch and hold the
START/PAUSE button for 3 seconds as in Step 7 to start the
dry cycle, or continue to set the dryer for Remote Start.
HELPFUL TIP: The cycle will be remembered for future use
until a different cycle is downloaded to the dryer.
NOTE: If the Download & Go button is touched without a
cycle ready for selection (with the indicator not lit), you will
hear an "Invalid Keypress" sound (if key activation sounds
are turned on).
16
u
) is illuminated. Check the Whirlpool™ app for additional dryer features,
q
Set a Remote Start
Remote Start mode allows you to start your dryer remotely
from the Whirlpool™ app.
After preparing your laundry load and selecting your cycle
settings, touch and hold the DOWNLOAD & GO button for
3 seconds. The Remote Start status indicator (
indicator above the Start/Pause button will begin blinking.
Touch and hold START/PAUSE to set the mode. The indicator
above Start/Pause will go out, and the Remote Start indicator
will be solidly lit.
When a Remote Start command is received from the app,
the dryer will start the cycle, causing the indicator above
Start/Pause to be lit (indicating running state). The Remote
Start indicator will remain lit.
HELPFUL TIP: Make sure that your dryer remains closed and
the cycle is not adjusted until you start the cycle. Any interaction
with the dryer itself after a Remote Start has been set will
cancel the Remote Start. If the dryer needs to be paused
to add garments, the Remote Start will need to be reinitiated.
NOTE: If no Wi-Fi connection is available, the Remote Start will
not be set. The Wi-Fi indicator (
go out. If the dryer is Wi-Fi connected but the Whirlpool™ app
service is temporarily unavailable, Remote Start can be set.
u
q
) and the
u
q
u
) will blink for 2 seconds, then
q