Whirlpool Cabrio WED8000D Operator's Manual page 11

9
OPTIONS
Use to select available options for your dryer.
Static Reduce
Touch to add the Static Reduce option to selected
Automatic cycles. The dryer will automatically tumble,
pause, and introduce a small amount of moisture
into the load to help reduce static. This option adds
approximately 8 minutes to the total cycle time.
End Beep
Use this to turn the signal indicating the end
of a drying cycle to low, medium, high, or off.
NOTE: You may also turn off the tones that sound
when a feature, setting, or option is touched. Touch
and hold End Beep for about three seconds to turn
sounds to low, medium, high, or off.
Damp Beep
Touch to select the Damp Beep signal. You may adjust
the signal to low, medium, high, or off. When selected,
a series of beeps will sound when the load is damp,
but not completely dry. This will allow you to take
clothes out of the load that do not need to dry
completely. This option is available on some cycles.
The Damp Beep signal is selected as a default for
the Bulky/Sheets cycle, as a reminder to manually
reposition bulky loads midway through the cycle.
Wrinkle Shield™ Option
If you will be unable to remove a load immediately,
touch Wrinkle Shield™ to add up to 150 minutes
of periodic tumbling to help reduce wrinkling.
NOTE: If you open the dryer door prior to the end of
the Wrinkle Shield™ option, the dryer will go into Pause
mode. You will need to touch Power to turn off or touch
Start/Pause to continue Wrinkle Shield™ option.
EcoBoost™ Option
Touch to activate the EcoBoost™ option, which
allows you to increase your energy savings by using
a slightly lower heat level. This will increase dry
times. EcoBoost™ option will default on for Mixed
Normal. Can be selected for: Mixed Gentle, Casual
Normal, Casual Gentle, Delicate Normal, and Delicate
Gentle. It will be not available for the other cycles.
Steam Refresh
This cycle is best for reducing wrinkles and odors
from dry items. Cycle time will increase depending
on number of items.
9