Advertisement
Installation
Integrated installations
34
Custom made front panels can be installed with models
ESW 4702 FB and ESW 4802 FB.
The custom panel must be at least
made of heat resistant material 140 °F (60 °C). The front
panel, including handle, must not exceed 11 lb (5 kg) in
weight.
^ Install a handle to the custom front panel using
countersunk screws.
^ Remove the screws from the left and right sides of the
drawer front and carefully lift the control panel out of the
drawer (see chapter "Aligning the appliance front")> Be
careful not to pull or damage the power cord.
^ Remove the two screws on the inner side of the drawer and
remove the panel from the appliance front.
^ Pre-drill the custom front panel (see illustration).
C
3/8" (10 mm), t = 3/8" (10 mm)
3
/
" (10 mm) thick and
8
Advertisement
