Storing Photos And Videos; Status Led Descriptions - dji ACTION 2 User Manual

Swipe Left or Right
Swipe left or right on the center of the touchscreen to switch between Photo, Video, QuickClip, Slow
Motion, and Timelapse shooting modes.

Storing Photos and Videos

The camera unit has a built-in storage capacity of 32 GB*, which can be used to directly store photos
and videos. Footage shot on DJI Action 2 can be stored on a microSD card (not included) when
connected to the front touchscreen module or power module. A UHS-I Speed Grade 3 rating microSD
card is required due to the fast read and write speeds necessary for high-resolution video data. Insert
the microSD card into the microSD card slot as shown.
* 22.4 GB of available storage.
DJI Action 2 only supports the exFAT file system. FAT32 is not supported.

Status LED Descriptions

If the front touchscreen module or the power module is connected to the camera unit, their status
LED blinking pattern descriptions will be the same as the camera unit. The status LED blinking pattern
descriptions is as below.
Blinking Pattern
Solid green
Off
Temporarily off
Blinks red once every second
During countdown:
10 to 4 s: blinks red once every second
3 to 2 s: blinks red twice every second
1 to 0 s: solid red
After countdown: temporarily off
Blinks red three times
Blinks red and green alternately
* Coming soon.
Description
Ready to use
No microSD card detected or insufficient microSD card
storage
While taking photo
While taking video, loop recording*, slow motion,
timelapse, hyperlapse, or QuickClip
Countdown to take photo
Camera powering off
Updating firmware
DJI Action 2 User Manual
©
2021 DJI OSMO All Rights Reserved. 14