Sony VGN-SZ110 Bluetooth&reg User Manual page 584

If the fax configuration information has already been registered, the [Send Fax Wizard] window, which can be viewed under "
o
Sending a fax" below, will appear instead of the [Fax Configuration Wizard] window.
5.
Enter the sender information, and click on the [Next] button
Note
The sender information that you configure here will be automatically appended as header information when you send a fax.
o
The [Fax Configuration Wizard (Select Device for Sending or Receiving Faxes)] window will appear.
6. Select a device to be used for fax transmissions, enable the device for sending or receiving, and then click on the [Next] button
Note
o If [Enable Receive] is selected, the device will be on standby for receiving faxes even if it is not sending or receiving anything,
and therefore will be in continuous connection to the wireless modem （ when
Please decide whether to select this option based on to the desired objective and/or frequency of transmission.
The [Fax Configuration Wizard (Transmitting Subscriber Identification (TSID))] window will appear.
7. Click on the [Next] button
It is important that you do not change the transmitter subscriber identification.
COM Auto Connect is on).
Page 584