Sony VGN-SZ110 Bluetooth&reg User Manual page 447

If the fax configuration information has already been registered, the [Send Fax Wizard] window, which can be viewed under "
o
Sending a fax" below, will appear instead of the [Fax Configuration Wizard] window.
5.
Enter the sender information, and click on the [Next] button
Note
The sender information that you configure here will be automatically appended as header information when you send a fax.
o
The [Fax Configuration Wizard (Select Device for Sending or Receiving Faxes)] window will appear.
6. Select a device to be used for fax transmissions, enable the device for sending or receiving, and then click on the [Next] button
Note
o If [Enable Receive] is selected, the device will be on standby for receiving faxes even if it is not sending or receiving anything,
and therefore will be in continuous connection to the wireless modem (when
Please decide whether to select this option based on the desired objective and/or frequency of transmission.
The [Fax Configuration Wizard (Transmitting Subscriber Identification (TSID))] window will appear.
7. Click on the [Next] button
It is important that you do not change the transmitter subscriber identification.
COM Auto Connect is on).
Page 447