Do you have a question about the iBT90 and is the answer not in the manual?
Questions and answers
Rawb
June 3, 2025
I bought a home bt speaker model IBT90 I can't get it to work red lights on for a bit then goes off I reset it red light comes then back off I can hear the speaker power on after reset but still no pairing
1 comments:
Rawb Randall
June 3, 2025
@Rawb Do you have any insight on why this is happening? And what I can do to get it to work?
Introduction Thank you for purchasing the iHome iBT90. This product is designed to provide high quality wireless sound for your iPad, iPhone, iPod, computer, PDA or other Bluetooth audio device. This instruction booklet explains the basic operation and care of the unit.
What’s Included • iBT90 speaker • USB charging cable iBT90 USB charging cable...
Page 4
Meet Your iBT90 Power On/O button Blue Bluetooth Status Red Charging Status Indicator Light Indicator Light Front Microphone Back Splashproof seal (press on lower left corner of seal first for easiest seal closing) Reset port USB In Port (charges unit)
(not included) USB AC adaptor connected to working outlet TIP: some (Apple) devices, you can view the iBT90 battery status on your device’s screen. When device is paired connected, look vertical battery icon next to the Bluetooth icon on the upper right corner of the device’s screen.
Page 6
Charging Devices Via USB Out Port (Charger is Disconnected and unit is ON) NOTE: The iBT90 will only charge devices when operating on the internal battery (when NOT connected to power source via the USB POWER IN port).The unit must be powered ON to charge devices via the USB Out Port.
Pairing Your Device Pairing is the set-up process to introduce your Bluetooth-capable device to the iBT90. Once your device is paired, the iBT90 can recognize it and you can play your audio through it. 1. Turn on your Bluetooth device and make it “discoverable”...
Bluetooth device. 2. Use controls on your Bluetooth device to play, pause and navigate tracks. 3. Press the + or – Button to adjust the iBT90 volume. You can also adjust volume on your device. 4. When done listening, press the Power On/O Button to turn the unit OFF.
Using the Playing Audio via Aux In Connect micro USB charging/audio cable to the Charging/Aux-in USB Port on the side of the unit and connect the 3.5mm audio plug end to the headphone or line-out jack on your audio device.
Make sure unit is completely charged. • Check that all connections are correct and properly plugged in. • Make sure your device is properly paired with the iBT90. • Make sure the unit is on Unit doesn’t respond (locked up/ “frozen”)
Internal Rechargeable Lithium-ion Battery This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it several times. If the battery does not recharge, please contact Customer Service at -1-800-288-2792.
FCC Information iBT90 FCC ID:EMOIBT84 FCC Radiation Exposure Statement IC:986B-IBT84 This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Consumer Product Safety Guide IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference.
L I M I T E D 1 Y E A R W A R R A N T Y iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase.
Need help?
Do you have a question about the iBT90 and is the answer not in the manual?
Questions and answers
I bought a home bt speaker model IBT90 I can't get it to work red lights on for a bit then goes off I reset it red light comes then back off I can hear the speaker power on after reset but still no pairing
@Rawb Do you have any insight on why this is happening? And what I can do to get it to work?