BRP Sea-Doo MOVE Operator's Manual page 19

219001876-022_a
TYPICAL
1. Winch support retaining nuts
2. Mounting plate
TIGHTENING TORQUE
Winch support
retaining nuts
To adjust front to rear winch position,
loosen the six (6) nuts, move forward
or rearward to desired position, then
tighten nuts as per the following table.
219001876-021_a
TYPICAL
1. Winch support retaining nuts
TIGHTENING TORQUE
Winch support
retaining nuts
Bow Stopper Roller
Set bow roller stopper so that it leans
on the PWC bow between rubber
bumper and bow eyelet (or bow cup
on selected models).
34 N•m (25 lbf•ft)
34 N•m (25 lbf•ft)
_______________
219001876-006_a
1. Area where the roller must lean
To adjust:
1. Loosen the four (4) winch adjust-
ment nuts as shown.
2. Set the bow roller stopper to the de-
sired height, then lock it in position
by tightening nuts as per the follow-
ing table.
219001876-020_a
TYPICAL
1. Winch adjustment nuts
TIGHTENING TORQUE
Winch adjustment
nuts
Bunks
Bunk Angle
To adjust the angle:
1. With the PWC off the trailer, loosen
the bolts retaining the bunk to its
support.
TRAILER SET-UP
34 N•m (25 lbf•ft)
17