4u rackmount intel xeon scalable series gpu server, supporting 10 x pcie x16 double-deck cards plus 1 x pcie x16 and 1 x pcie x8 singledeck cards (102 pages)
Ltd. NOTE: The information in this document is provided for reference only. Advantech does not assume any liability arising out of the application or use of the information or products described herein. This manual is subject to change without notice.
• Dimensions: 19" (W) x 8.75" (H) x 26" (D), 482 mm (W) x 222 mm (H) x 660 mm (D) • Net weight: SPC-530MB / SPC-530BP: 46.2 lb (21 kg) - - - - - - - - - - - - SPC-530 User's Manual...
Page 5
Passive backplane options (for SPC-530BP / SPC-530BP-U2C) RAID card features (only for SPC-530BP-U2C / SPC-530MB-U2C) The SPC-530 is available with a RAID to PCI host interface. This gives users numerous extra features. (For more details, please refer to our RAID manual, under SPC-530BP-U2C / SPC-530MB-U2C) •...
Page 6
" Beep x Beep x ..." alarm. Controls for the system The SPC-530 series' front panel provides one soft switch and one system reset button to re-boot the PC system. See the following figure:...
1.4 Dimensions SPC-530BP (Can be fitted SPC-530MB (Can be fitted SPC-530 User's Manual with a 20-slot backplane) with a 12" x 13" motherboard) Unit = mm...
EIA RS-310C 19" rackmount standard. Setting up your SPC-530 series requires only a screwdriver and a small amount of time. Before you begin, you should also gather together all of the cards you plan to install, as well as the disk drives you plan to use.
There are three cooling fans inside the chassis. To replace or service the fans, open the top cover as in Figure 2.1. Loosen the thumbscrews, and pull out the whole fan assembly. Please refer to Figure 2.3 below: SPC-530 User's Manual 2.2 Removing the handles 2.3 Cooling fans...
The default of the "RF_JMP" is PIN1-2: ON, which enables redundant power detection. Temperature can also be selected (via SW1) on the alarm board inside the chassis: TEMP 2.5 Inserting the drives into the drive bay C (149 F) (default setting), the LED changes color from 2.6 Alarm board SPC-530 User's Manual...
2.6 Installing the power supply unit There is one 400 W ATX redundant power supply installed at the front of the chassis. The power module can be hot-swapped for maintainence. 2.7 ATX redundant power supply SPC-530 User's Manual...
STORAGE TEMPERATURES BELOW -20 MAY DAMAGE THE EQUIPMENT. The sound pressure level at the operator's position according to IEC 704-1:1982 is equal to or less than 70 dB(A). SPC-530 User's Manual C (-4 F) OR ABOVE 60 C (140 F), AS THIS...