Advertisement
Quick Links
This procedure will assist if your IPG100 portrays the following symptoms:
•
This IPG100 is not visible on the device list within N2KAnalyzer or DSM display.
•
®
The NMEA 2000
(the below image shows an example of this).
We must first make the drive Active (Bootable).
Insert your USB flash drive (32GB or smaller) into your PC and proceed with the follow instructions.
To make partition Active:
1. Run Command Prompt as Administrator
2. Type: diskpart
3. Type: list disk
Remember the desired disk number, match size of drive
4. Type: select disk #
where # is the desired disk number
5. Type: list part
Remember the desired partition number
6. Type: select part #
where # is the desired partition number
7. Type: active
REV 2.0: 12/20
Maretron IPG100 Recovery
light on the IPG100 is a solid red color, and not the normal flashing green light
1 |
P a g e
Advertisement
Related Manuals for Maretron IPG100
Summary of Contents for Maretron IPG100
- Page 1 • ® The NMEA 2000 light on the IPG100 is a solid red color, and not the normal flashing green light (the below image shows an example of this). We must first make the drive Active (Bootable). Insert your USB flash drive (32GB or smaller) into your PC and proceed with the follow instructions.
- Page 2 To view and confirm your drive status 1. Press the Win + R keys on your keyboard to open Run 2. Type: diskmgmt.msc __________________________________________________________________________________________________ Downloading System Files 1. Download the factory firmware image ZIP file from the link at the bottom of these instructions (it is named "IPG100_RCV.zip").
- Page 3 9. Plug the N2KView license key into the USB port of the IPG100, if applicable The USB light should turn green after a short time. 10. The IPG100 is now running with the factory default configuration, you may now utilize either N2KAnalyzer or a DSM display to restore any configuration you require.