Heath Zenith HZ connect 9304 Manual page 2

IMPORTANT SAFETY AND INSTALLATION INFORMATION
Before installing security light, read all instructions carefully and keep owner's manual for future reference.
• WARNING: To prevent possible SERIOUS INJURY or DEATH never allow small children near batteries. If a battery
is swallowed, immediately notify a doctor.
• WARNING: DO NOT mix old and new batteries. DO NOT mix battery types - such as alkaline, heavy duty, and
rechargeable - in a single device. Battery leakage may occur.
• WARNING: DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK.
• WARNING: Risk of fire. Keep the lamp head at least 2 in. from combustible materials.
• CAUTION: To avoid water damage, the motion sensor controls must be facing the ground when the installation is
complete.
• CAUTION: Keep the lamp head 30° below horizontal to avoid water damage.
• CAUTION: Burn hazard. Allow the light fixture to cool before touching.
• NOTICE: Do not immerse components in liquid.
• This light fixture requires 4 "D" alkaline batteries (not included).
• To extend the life of the batteries, this light only works in the dark (night time).
• This fixture is designed for outdoor installation and should be mounted to a wall or eaves.
• To achieve best results, this fixture should be mounted 8 feet (2.4 meters) above the ground. Note: If fixture is mounted
higher than 8 ft. (2.4 meters), aiming the sensor down will reduce coverage distance.
The motion sensor on this light fixture detects "motion" by the movement of heat across the coverage area. The motion
sensor is more sensitive to the movement of heat moving across the coverage area and less sensitive to the movement
of heat directly towards it.
Note: Light fixture and sensor should be mounted as shown above when installed (depending upon type of installation).
2
Motion
Least Sensitive
Wall Mount
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Motion
Sensor
Most Sensitive
Eave Mount
210450-01